I bought the device NOVA V8 ORANGE
I'm trying to scan AMOS but it scans other satellites, showing channels that AMOS does not transmit
I thought the software problem updated the software to V8NOVA_relase_20180817
But it did not help, I do not find the channels like the old converter, is there a solution?
The scan is not performing correctly
Moderators: admin, GTMedia Team
Re: The scan is not performing correctly
You may not have the "Antenna Settings" set correctly for your set up.
Look on your old unit and check what DiSEqC 1.0 and DiSEqC 1.1 LNB Frequency and 22kHz setting you had and then set them in your Nova.
There are instructions here on setting up units.
Owen
Look on your old unit and check what DiSEqC 1.0 and DiSEqC 1.1 LNB Frequency and 22kHz setting you had and then set them in your Nova.
There are instructions here on setting up units.
Owen
Dishes; 3x3m, 2.4m and 4.1m, 10+ ku, 2 movers, USARLS. V8 Combo, Pro, V8 Golden, Nova V8Pro2, GTC, Super.V7HDs, Combo and V7s V7Plus Finder, Finder-Meter V8X / UHD V7Pro GT/XCombo. Sats 100.5E to 177W. I'm a Sat hobbyist who helps out.
-
- Posts: 5
- Joined: Thu Oct 11, 2018 5:33 pm
Re: The scan is not performing correctly
thank you for quick answer, in old setup I have DiSEqC = 3/4 , in NOVA setup I have more option DiSEqC 1.0 , DiSEqC 1.1 ,motor
How do I adjust the settings? I have 2 dishes set up
How do I adjust the settings? I have 2 dishes set up
Last edited by daniel_hp9 on Fri Oct 12, 2018 7:07 am, edited 1 time in total.
Re: The scan is not performing correctly
DiSEqC 1.1 is used for 8 port switches.
You use them first and the cable to DiSEqC 1.0 4 port switches.
The 1.1 switch latches so the command for the second switch can pass.
If you only have a single small switch 4 ports or less,use DiSEqC 1.0.
As you say 3/4 then set for port 3 on DiSEqC 1.0.
Also set your correct LNB frequency and any 22kHz setting as well.
Good luck
You use them first and the cable to DiSEqC 1.0 4 port switches.
The 1.1 switch latches so the command for the second switch can pass.
If you only have a single small switch 4 ports or less,use DiSEqC 1.0.
As you say 3/4 then set for port 3 on DiSEqC 1.0.
Also set your correct LNB frequency and any 22kHz setting as well.
Good luck
Dishes; 3x3m, 2.4m and 4.1m, 10+ ku, 2 movers, USARLS. V8 Combo, Pro, V8 Golden, Nova V8Pro2, GTC, Super.V7HDs, Combo and V7s V7Plus Finder, Finder-Meter V8X / UHD V7Pro GT/XCombo. Sats 100.5E to 177W. I'm a Sat hobbyist who helps out.
-
- Posts: 5
- Joined: Thu Oct 11, 2018 5:33 pm
Re: The scan is not performing correctly
WORK GREAT! thanks!!!