Page 1 of 1

Adding cccam lines

Posted: Fri May 18, 2018 7:50 am
by red devil
Hello,

I have 5 C lines to add to the deco.

What is the best way to add them? Only with the remote?

Thank you

Re: Adding cccam lines

Posted: Fri May 18, 2018 12:37 pm
by mikelsat
You can add them manually or by USB, the less lines you have the better they work, I've only ever used one line.
Create a cam file in notepad, save as CCcam.cfg (Save as type - All Files)
Each line should look like this in notepad
C: Server Address port ID password
Put the file on on a USB,
Insert USB, - Menu - Network - Press 6666 - CS Protocol - CCcam, - USB Account, press OK - load the cfg file
Save and press Apply to confirm, status should show "ECM ready" when connected.

Re: Adding cccam lines

Posted: Mon May 21, 2018 8:14 am
by saleupse
mikelsat wrote:You can add them manually or by USB, the less lines you have the better they work, I've only ever used one line.
Create a cam file in notepad, save as CCcam.cfg (Save as type - All Files)
Each line should look like this in notepad
C: Server Address port ID password
Put the file on on a USB,
Insert USB, - Menu - Network - Press 6666 - CS Protocol - CCcam, - USB Account, press OK - load the cfg file
Save and press Apply to confirm, status should show "ECM ready" when connected.
In my case I have to write the file name cccam in lowercase letters otherwise the receiver does not recognize the file.

Re: Adding cccam lines

Posted: Mon May 21, 2018 9:11 am
by red devil
For me it worked with that format

CCcam.cfg

Thanks guys