Page 1 of 1
no remote control - sr33 error
Posted: Thu Jul 12, 2018 5:45 pm
by fridgex
Hi , after software update, my remote control is not working on v8 golden.
When i power on: i see BOOT, LOAD, SR33 and then channel number.
The POWER-ON/OFF, channel-UP and channel-DOWN buttons on the outside of the box are working OK.
But i need the remote control to work.
the remote control is ok, i tested it with my mobile phone camera.
flashing over rs232 works fine, i've tried old and new v8 golden firmware, but remote is not working.
can u help ?
Re: no remote control - sr33 error
Posted: Thu Jul 12, 2018 8:52 pm
by Feralkiwi
When remote batteries get low the remote will send incorrect codes.
Also are you seeing any picture?
It may be that you have a NTSC TV and the unit is sending PAL.
They added this feature.
Added fast key to switch video output mode or format.
we try to support some old TV or some signal mode TV
Press menu key to main menu.(Panel show "----")
press Green key to switch NTSC/PAL, the panel will show "PAL " or "NTSC"
Press Stop key to switch the video format
PAL mode : the panel will show "576I" -- "576P" -- "720P"(50HZ) --"1080I"(50HZ) --"1080P"(50HZ)
NTSC mode : the panel will show "480I" -- "480P" -- "720P"(60HZ) --"1080I"(60HZ) --"1080P"(60HZ)
Owen
Re: no remote control - sr33 error
Posted: Sat Jul 14, 2018 1:06 pm
by fridgex
It's working again !
TY.
Re: no remote control - sr33 error
Posted: Sat Jul 21, 2018 10:51 pm
by Fyx
Feralkiwi wrote:When remote batteries get low the remote will send incorrect codes.
Also are you seeing any picture?
It may be that you have a NTSC TV and the unit is sending PAL.
They added this feature.
Added fast key to switch video output mode or format.
we try to support some old TV or some signal mode TV
Press menu key to main menu.(Panel show "----")
press Green key to switch NTSC/PAL, the panel will show "PAL " or "NTSC"
Press Stop key to switch the video format
PAL mode : the panel will show "576I" -- "576P" -- "720P"(50HZ) --"1080I"(50HZ) --"1080P"(50HZ)
NTSC mode : the panel will show "480I" -- "480P" -- "720P"(60HZ) --"1080I"(60HZ) --"1080P"(60HZ)
Owen
wow, never knew about this will try on my v8 golden thanks