We are flashing with Rs232 V9 prime cable

sadolina@t-com.me · Post by **sadolina@t-com.me** » Tue Nov 28, 2023 12:05 pm

When inserting the software with the rs232 cable into the V9, it gave me an error message, maybe I'm not inserting the right file, please, which file goes, where can I download it, I need to restore it from the mars firmware to the ecam firmware.Thanks

Post by **CAJE** » Tue Nov 28, 2023 5:09 pm

On the V9 requires a higher quality RS232 cable

sadolina@t-com.me · Post by **sadolina@t-com.me** » Tue Nov 28, 2023 5:17 pm

The cable is from the old receiver which was repaired for V9 according to the procedure that exists in the forum.

sadolina@t-com.me · Post by **sadolina@t-com.me** » Tue Nov 28, 2023 5:23 pm

I'm not sure which file is in the one indicated below, I put the normal firmware there because that's fine?

GTMEDIA Forum

We are flashing with Rs232 V9 prime cable

We are flashing with Rs232 V9 prime cable

Re: We are flashing with Rs232 V9 prime cable

Re: We are flashing with Rs232 V9 prime cable

Re: We are flashing with Rs232 V9 prime cable